Small Tangiers Phunnel, Too Big For My Qt. Electrical Tape?

Pardon if this should go in the drunk texting thread, since im not exactly sober, but I need some help/suggestions after opening my QT today. The gasket is on the QT but my small tangiers phunnel is so much bigger then it that there is nothing close to an air tight seal. I was thinking electrical tape would do the trick to make the seal air tight but wasn't sure if that would be okay to use, for the time being before I order a seal that would work, if one exists. So what are your experiences with this? I know Chris had (has?) a QT and im assuming used a tang phunnel on it at some point, so what can I use momentarily so that it fits snuggly?And is there any suggestions for where I could find a gasket that would allow it to fit snuggly without any mods.

Thanks guys.